industrial tablet computer

Common Causes And Solutions of Industrial Tablet Computer Crashes

Common Causes And Solutions of Industrial Tablet Computer Crashes

With the continuous popularization of industrial tablet computer applications, more and more companies gradually introduce their use. While the equipment is running, it is inevitable that there will be some failures. When the industrial tablet computer crashes, how can we solve it?

To better solve the problem, we must first find the cause of the problem.

1. Poor internal heat dissipation of industrial tablet computers

Industrial tablet computers are in a harsh environment, in addition to high temperature, there is also a lot of dust. When dust enters the industrial computer, the heat dissipation effect of various boards, CPUs and other electronic components is poor, causing the industrial pc to "crash".

Tips: Clean the dust inside the industrial tablet regularly and keep it well ventilated.

2. Frequently clean up temporary files

When the industrial computer is running, it will generate a large number of temporary files. These files occupy the hard disk and system resources and affect the speed of the industrial tablet computer to process information.

Tips: Regularly check the hard disk and delete temporary files to improve the speed of processing information on the industrial tablet.

3. The amount of data is too large and the CPU efficiency is low

When the industrial panel computer processes too many field signals transmitted by the PLC, the CPU efficiency of the industrial panel computer is low, and the memory is small, and it cannot recognize and process so many signals at the same time. These signals "crash" and cause the industrial panel computer to crash.

Tips: Due to the limitation of the memory slot of the industrial panel computer motherboard, intelligently expand the memory to 64M. The main solution is to reduce the frequency of processing and identifying on-site signals by industrial tablet computers to avoid signal "car crashes".

4. Check the CPU fan and host power supply fan

The heat dissipation of industrial tablet computers is mainly carried out by CPU fans and power supply fans. When the CPU fan is damaged, the temperature of the CPU rises, which can easily cause the industrial panel computer to "crash".

Tips: Check the fan of the industrial panel computer frequently, and replace the damaged fan in time. When the industrial panel computer in the central control room leaves the factory, only a heat sink is installed in the CPU, without a fan, and a special cooling fan is installed later, and the temperature of the CPU is reduced by nearly 5°C.

The above are the possible reasons for the crash of industrial tablet computers. In general, in addition to correct operation, necessary maintenance is also required. Pay attention to the temperature during use, and often clean up temporary files. Pay attention to these matters. It can reduce the occurrence of "crash" of industrial tablet computers.

There are two main related reasons for the "crash" of daily industrial tablet computers. Board failures and system failures are the most basic and core parts of hardware and software, and their applications are crucial. So this requires us to follow the precautions and repair and maintain in time when we usually apply.

コメントを残す

*必須フィールド

注意:コメントは公開する前に承認する必要があります。